|
Lee- Enfield #1
Mk3, #4 Mk1, + Mk2, Ishapore, + Gibbs |
SMLE
Installation Instructions
1.
Make sure firearm is unloaded
and in safe operating condition. Do NOT install this trigger if
Safety, Sear or Cocking piece worn or damaged.
2.
Remove forearm stock from
barreled action.
3.
Remove trigger pin and
separate trigger from triggerguard or action.
4.
Install Huber trigger and
re-pin to action.
5.
Remove wood triangle in
forearm stock to clearance creep screw boss (figure 2). Typically
use a ROTOZIP or DREMEL tool.
6.
With floorplate attached to
action, adjust creep screw (1) to position trigger at front of
floorplate slot.
7.
With bolt closed, adjust ball
screw (2) up to release point AND back off ½ turn. For more creep
or 2stage function – back off a little more. Minimum safe sear
engagement is .015in. or more!
8.
With bolt closed, adjust
screws to fine tune for function, half-cock and feel. Release point
is where trigger will fire the gun.
9.
Reassemble forearm stock to
barreled action.
10.
Cycle firearm for function and
fine tune for desired feel. Drop Test!
11.
Enjoy shooting Mil-Surp rifles
with your new HUBER CONCEPTS precision anti-friction ball trigger.
SAFE FIREARMS HANDLING
RULES
1.
Treat every firearm as if
it were loaded.
2.
Control the muzzle.
3.
Know your target and
beyond.
4.
Keep finger away from
trigger until ready to fire.
|
