Mosin-Nagant Installation
Instructions
1.
Make sure
firearm is unloaded and in safe operating condition. Do NOT install
this trigger if Safety, Sear or Cocking piece worn or damaged.
2.
Remove
barreled action and floorplate from stock assembly.
3.
Remove
trigger pin and sear screw and separate trigger from sear and
action.
4.
Install Huber
trigger and re-pin to action and screw sear to action.
5.
Before
inserting bolt and with floorplate attached to action, adjust ball
screw to just take up slack in trigger assembly. For more creep or
2stage function – back off a little more. Minimum safe sear
engagement is .015in. or more!
6.
With bolt
closed, adjust screws to fine tune for function and feel. Release
point is where trigger will fire the gun.
7.
Reassemble
stock to barreled action.
8.
Cycle firearm
for function and fine tune for desired feel. Drop-fire test for
secure sear engagement.
9.
Enjoy
shooting Mil-Surp rifles with your new HUBER CONCEPTS precision
anti-friction ball trigger.
SAFE FIREARMS HANDLING
RULES
1.
Treat every firearm as if
it were loaded.
2.
Control the muzzle.
3.
Know your target and
beyond.
4.
Keep finger away from
trigger until ready to fire.
