30-40 KRAG-JORGENSEN
1892-1898SPRINGFIELD Install Instructions
1.
Make sure
firearm is unloaded and in safe operating condition. Do NOT install
this trigger if Safety, Sear or Cocking piece worn or damaged.
2.
Remove action
Screws & barrel Bands, then Remove barreled Action from Stock.
3.
Swing Sear
down to clear action Slot and compress spring. Sear & trigger come
out to the left.
4.
Remove
trigger PIN and replace with Huber trigger and re-pin to sear.
Reinstall SEAR
5.
Remove wood
in stock to clearance screw boss at front of trigger (figure 1).
Typically use a ROTOZIP or DREMEL tool.
6.
With bolt
closed, adjust creep screw (1) up to release point AND back off ¼-½
turn. For more creep – back off a little more. Minimum safe sear
engagement is .015in. or more! Ball adjustment is base set for
clearance of trigger back.
7.
With bolt
closed, adjust screws to fine tune for function or personal
preference. Release point is where trigger will fire the gun.
8.
Reassemble
barreled action to stock, screws & bbl bands.
9.
Cycle firearm
for function and fine tune for desired feel. Drop Test!
10.
Enjoy
shooting Mil-Surp rifles with your new HUBER CONCEPTS precision
anti-friction ball trigger.
SAFE FIREARMS HANDLING
RULES
1.
Treat every firearm as if
it were loaded.
2.
Control the muzzle.
3.
Know your target and
beyond.
4.
Keep finger away from
trigger until ready to fire.
